Full Time Pixie @elfi@pixie.town

https://www.banggood.com/RGBDuino-UNO-V1_2-Jenny-Development-Board-ATmega328P-Chip-CH340C-VS-UNO-R3-Upgrade-for-Raspberry-Pi-4-Raspberry-Pi-3B-Geekcreit-for-Arduino-products-that-work-with-official-Arduino-boards-p-1732472.html?cur_warehouse=CN

...I want it just because it's pink but also because I'm gay

What I should be doing: Dishes, laundry, D&D prep

What I am doing: crying over cute moth videos

moths... so baby.... ;w;

Made sausage and stamppot with the last of the potatoes, with cabbage and green onions for the veggies. Not the most traditional but I'm not sure if I can even get endive in this area...

I should probably denote a set of pants for painting/printing... and maybe get a cute apron that I don't mind getting dirty

tfw I completely forgot to put a drainage hole on my test prints

now after cutting them open my room smells like resin and I gotta vent it when I wqas getting ready to go to bed instead weh

tonight, the IPA jar is gay scalebaby jail again

Oops, I accidentally mixed in the gel medium and not the matte medium... time to start over on that mini tomorrow...

@bunny_jane I was googling around to see if there were any practical solutions to the issues you had with resin and silicone moulding since it very much was a problem I'd likely encounter if I dug into it myself, and I found an article talking about inhibit-x which might be helpful in future moulds! https://joshuawoehlke.com/curing-silicone-in-sla-uv-molds-part-2/

if I'm not careful I'm gonna start crying and hugging my plush moths because they're such sweet wonderful children again ;w;

I love moths...