Elfi, known bug enjoyer @elfi@pixie.town

@popstar@rage.love glass cactus sounds like it could totally be a thing about creation and beauty in unexpected places but also will totally fuck you up with a thousand needles

@rezzish (based on data of myself, who last had a ref sheet in... 2006)

@rezzish ref sheets are ~soooo~ 2006

@SophicLeech @decimal@the.monsterpit.net my sister literally does this

@sharkNserg *turns into a morb, rolls over, wiggles leggies* does this count?

@bunny_jane ooooh! Do you have a link or picture? c: I'm curious

I should probably denote a set of pants for painting/printing... and maybe get a cute apron that I don't mind getting dirty

tfw I completely forgot to put a drainage hole on my test prints

now after cutting them open my room smells like resin and I gotta vent it when I wqas getting ready to go to bed instead weh

@kat I had other stuff going on today, sorry! Hope you have fun with folks

tonight, the IPA jar is gay scalebaby jail again

Oops, I accidentally mixed in the gel medium and not the matte medium... time to start over on that mini tomorrow...

@rezzish then the gentle spread of a moth's wings shall be your lämpshade

@bunny_jane Oh! Haha, my bad then :'D I'll have to keep that in mind in the future then

@rezzish Then lämp must be free

@bunny_jane I was googling around to see if there were any practical solutions to the issues you had with resin and silicone moulding since it very much was a problem I'd likely encounter if I dug into it myself, and I found an article talking about inhibit-x which might be helpful in future moulds! https://joshuawoehlke.com/curing-silicone-in-sla-uv-molds-part-2/