quad build progress update:
DONE:
- figure out locations for everything
- solder ESC's and mount motors
- 3d print both propguards
- LiPo leads, connector and smoothing cap
TODO:
- connect camera, VTX, receiver to flight controller
- receive the right propellors, and longer screws for the motors+propguards (tomorrow most likely)
- finish PCB designs for VTX+receiver mount and decorative backside (soon(tm))
- receive new transmitter, and swap out the corresponding receiver (soon(tm))
so uh earlier today after basically everything worked, I accidentally shorted something and fried the STM32 chip that brains it all...
ordered a replacement for just the STM32 and hope that's all that needs replacing
did get a real nice pic before that tho