Full Time Pixie @elfi@pixie.town

Found a neat calibration print for my printer, and the results of the tests are in!

...The verdict is my resin is way too ｔｈｉｃｃ

Insomnia, and it's not even over any ideas banging around in my head wanting to be recorded, just plain old anxiety. Yyyep

The fediverse is clearly giving me positive reinforcement to draw more moths

I need a better apron. The one I got for $3 is fine for a basic one, but the front is so narrow that if I don't wear a bra my boobs just fucking shoot out sideways

I'm terrible at holding myself to things, but in my defence, I'm restless and have been drawing a bunch of little things

I think I'm going to spend today drawing stuff, away from all... *waves arms around mothily* this. I'll catch you all later

Did a test print of the 110 film negative holder I'm printing out for my mother, there's a problem in that it is way too flimsy to get a viable splice joint, but the standard resin I have can otherwise hold up to a decent amount of deformation before breaking, and doesn't seem prone to delamination under stress either.

@kat the heater's broken in my building, can I use you as a featherpillow