Elfi @elfi@pixie.town

@Griever@shrike.club baby boy. baby

I had

to upload the firmware during device initialization in Linux

AND THEN let it go to Windows

I am s c r e a m i n g no wonder it was barely functional

@kat If your part in the conversation is because of replies to you, you can choose "Mute conversation" on the options for your post, hopefully that'll work

I think I'm gonna need to start mixing resins and finetuning cure times, these kobolds came out very brittle and a bit overexposed during printing .w. also need to use a different slicer for supports

Well, that bluetooth dongle didn't last long before just giving up

3D printer status: After a harrowing cleanup of the corrupted print yesterday, and the salvage of most of the resin, I managed to eke out one last print. Result: some kobolds melted, but I have a small group of lizers to clean and cure now!

@Zest Ha ha ha ha...

@deejvalen yes? c:

bev, meme

Today, on the first of December, after three and a half years... everything is going to be okay again

@astra grats!!

@karma big same

@Zest ...holy crap it just hit me that I haven't heard a dial tone firsthand in a decade

@noelle pls don't break lämp ;^;

@Zest I found where these were located at my local no frill's but I was with my roommate and thus was too chicken

@Zest I should see if this is at my no frills 👀