In order to get a vagina I have to spend my life savings to pay someone to electrocute my balls over and over again for at least half a year, like some sort of evil ritual.

I'd be kinda into it, in a "wow that's brutal" kinda way not a kinky kinda way, if it wasn't going to take away literally all my money :<

Just hoping I can figure out a way to afford both a new 3d printer ($400-ish) and all the hair removal I need to get before surgery ($2,000-ish).

Tomorrow I'll start investigating getting my insurance to cover the zappy zaps.

@bunny_jane oh no, what happened to your printer? D:

@elfi Nothing it's just a pain in the butt to clean up the toxic chemicals every time I run it. I basically can't use it because I can't get myself together well enough to clean it.

Even when I do feel up to cleaning it, knowing I'll have to clean it is a huge deterrent to printing anything unless I have no other way of fabricating it.

So I want to get an FDM printer.

@bunny_jane oh, yeah, I get you .w. I found a few dollar store items made it a lot easier to work with--aluminum trays, tupperware with locking gasket lids, a silicone spatula, a spraybottle for IPA, some shop towels or j cloths for cleaning the resin vat, and when I don't need fine manipulation, a cheap pair of reusable rubber gloves...

I've been having a bad string of failed prints lately though and it turned out my FEP sheet had leaked a bit x_x that was exhausting to deal with and burned me out on printing for a bit